Where is sweep in revit 2011

Message 1 of 8. See attached image Not sure why they would really change this feature so drastically considering how important they are to any size project Preview file.

Tags 3. Tags: Extrusions. Message 2 of 8. Message 3 of 8. Message 4 of 8. Oh, in-place models. That's right. My mistake. Those are not included in Revit LT.

Message 5 of 8. Message 6 of 8. Message 7 of 8. Message 8 of 8. Thanks for the help. Post Reply. Page of 1. Filtered by:. Previous template Next. Sweep on 3D path February 26, , PM. Here is what I'm trying to achieve. The model shown is created with a sweep following a path drawn on the surface of the wall, and then copied around, but as you can see that creates the overlapping at the endpoints.

Not satisfactory to say the least. Could use some advice Thx ppl. Tags: None. February 26, , PM. Hi, You should be able to pick the 3D edges during sweep creation. Just make sure that the workplane is set to a level and not the wall face or anything else. It's definitely possible as you can see on the image below. I know that's not the whole thing , but I have to do some work :banghead: sweep. Maciej Wypych Bibere humanum est, ergo bibamus! Comment Post Cancel.

February 27, , PM. Yup, that the way to do it My workplane was set to a wall However, I couldn't sweep it in this case due to the shape of the path and profile.

Sometimes revit cant create sweep My fix was to create one sweep and cut it on the ends and then copy it around. Steps may vary depending on your design intent. To create a solid or void sweep. The path can either be a single closed or single open path. You cannot have multiple paths. The path can be a combination of straight lines and curves, and it need not be planar. To select edges of other solid geometry, such as extrusions or blends, click Pick 3D Edges on the ribbon.

Or pick existing sketch lines, watching the status bar to know what you are picking. This method of picking automatically locks the sketch lines to the geometry you are picking and allows you to sketch the path in multiple work planes, hence allowing for a 3D path. If the profile you need is not already loaded in the project, click Modify Sweep tab Sweep panel Load Profile to load the profile.